RUBBER MATS for ELECTRICAL PURPOSES

Our Rubber mats are confirming to IS-5424 norms. Application Rubber mats are used as floor covering around electrical panels as a safeguard to the life and limb of the workmen due to possible leakage of current and short-circuit. Rubber mats are used in power generation plants, sub-stations, workshops etc.

Construction

Composition	Manufactured out of rubber compound of high quality natural rubber.
Surface	The rubber mats have chequered, anti-skid fluted design orplain on one side and plain at bottom as per the requirement of the purchaser.
Thickness Range	8.5 mm to 25 mm for chequered or fluted 6.5 mm to 25 mm for plain.
Length x Width	2.0 mtr x 1.0 mtr., 1.8 mtr x 0.9 mtr
Colour	Black unless otherwise specified by the purchaser. Any colour can be provided on demand.
Technical	Tensile strength 50 kgf/cm2
Particulars	Elongation at break 250%
Volatage Test	The rubber mats are tested to pass the voltage test at 15000 volts for one minute without any puncture or warming effect.
Breakdown Strength	Shall not fail at less than 40000 volts as per the procedure outlined in IS : 2584/83.